TC ELECTRONIC G-SHARP Instruction Manual

STORE - RECALL & THE G-SHARP DISPLAY
Edited knobs LEDs
Preset ModesDisplay
The G-Sharp holds two significantly differentEdited knobs LEDs
modes. To toggle between these modes press(relevant only in ?Preset On? mode)
the PRESET ON/OFF key.These LEDs refer to the 9 front panel controls.
See illustration above. (no LED for the INPUT
?Preset On? modeknob).
In this mode it is possible to load any of the
previously stored presets.When the LEDs are lit they indicate when the
The ?Preset On? mode is active when thefront controls match the current settings of the
display shows location numbers from 1 to 99.active preset.
When changing the position of a knob the
corresponding LED is off/unlit.
If you try to load a preset from a location
where no preset is stored - no action willLoad/Store Presets
take place.Load User Preset
? Enter ?Preset On? mode using the PRESET
ON/OFF key. The G-Sharp is in Preset On
?Preset Off? modemode when the display shows location-
In Preset Off mode the G-Sharp will processnumbers 1 to 99.
the signal according to the position of the frontUse the UP/DOWN arrows to select the
controls. A ?what you see is what you hear? -desired preset (1-99).
setting.? The digits are now blinking to indicate that
you are previewing the preset and it has not
yet been recalled.
? Press LOAD to recall the preset and the
digits are now steady.
Once you have accessed the Preset OffStore User Preset
mode and return to the Preset On mode? Enter ?Preset On? mode using the PRESET
the preset number will blink indicatingON/OFF key. The G-Sharp is in Preset On
that you must press LOAD to recall themode when the display shows location-
settings stored with that particular preset.numbers 1 to 99.
? Use the UP/DOWN arrows to select desired
preset location where you intend to store the
preset (1-99).
? The digits are now blinking to indicate that
you have not yet stored the preset.
? Press and hold the LOAD (HOLDTOSTORE)
key for approx. 2.5 seconds until the digits turn
steady.
20